Somehow Jim and being at IDEO make everything work out. We’re now done with the secondary ramps and have mounted a main ramp on hinges connected to the chassis (and removed it, so electronics could flip the chassis and drill a couple holes). Our next plan for action is to figure out how to mount the vertical ramp supports and the dampers on the ramps. I think we’re sticking to the cable idea for aligning the supports. We also have somewhat of an idea to mount the dampers (we did all of this on our prototype!), but this needs some reworking because the top back chassis rail isn’t one piece straight acros the width of the frame. Rather, there’s a gap in the middle, leaving no room to mount a damper.
The gap is, however, a perfect fit (as it was intended to be) for the new gripper design that is similar to our previous design, except it has two prongs spaced >10″ (the diameter of the spider arm circular plate). We need to finalize this tomorrow and fabricate it, too…and test it on THE RACK! Once this design is set, we also need to add cross bracing to the tower at heights that’re appropriate for mounting touch sensors (to prevent the arm from rotating too much in either direction).
The battery mount is also in progress and will hopefully be done by the end of tomorrow.
On top of all the stuff already listed above, PLEASE READ THE LAST FEW BLOGS FOR OTHER THINGS THAT STILL NEED TO BE DONE.
[OI board? (currently we’re using last year’s–is this even legal?)
bumpers, signage, flag holder, etc.
crate! contact mr. reichling… (Kersten?)]
Little stuff that I don’t want to be doing the night before/the day of ship…
A big thanks to Jim for staying with Chrissy and me these past few days until AFTER 10:00!!